vero ion chamber

This is bound to get mixed up with things in Electronics, check both. Physics-specific stuff here, mostly.

vero ion chamber

Postby Starfire » Sun May 12, 2013 3:16 pm

Photo of a Vero board Ion Chamber Alpha detector made with Tungsten foil and Tantalum wire and a 555 pulse shaper.
Posts: 143
Joined: Thu Aug 05, 2010 4:26 pm
Location: North Ireland

Re: vero ion chamber

Postby Doug Coulter » Wed May 22, 2013 1:30 pm

I take it you're going to make one of those things that makes sparks where the ions are produced by a nearby source? Those are pretty darn cool. I guess this would make a fine ion chamber too - though the leakage through the phenolic would tend to obscure the real signal in usual ion chamber conditions where the ion currents are VERY small.
Can't wait to see some results from this! I've been planning one myself, though I don't now have a nice super hot alpha source in hand. My old staticmaster brush elements are a couple half lives old at this point.
Posting as just me, not as the forum owner. Everything I say is "in my opinion" and YMMV -- which should go for everyone without saying.
User avatar
Doug Coulter
Posts: 3038
Joined: Wed Jul 14, 2010 7:05 pm
Location: Floyd county, VA, USA

Return to Metrology

Who is online

Users browsing this forum: No registered users and 2 guests